Black & Decker BPWM09W Mode D'emploi page 18

SET UP & USE
Pull down on the white ring
to divide the adaptor into
two parts.
Top part: Faucet fitting
Bottom part: Hose fitting
PERMANENT CONNECTION
• Connect the ends of the water supply hose to the COLD faucet.
• Tighten the fittings by hand until they are snug, and then tighten them an additional
two-thirds of a turn with a wrench/pliers.
When you fasten the fitting, do not fasten it too tightly or apply tape or
sealant to the faucet or water supply intake. This can damage the fitting. After
you have connected the water supply hose to the faucet, ensure that it is
connected securely by pulling the water supply hose downwards.
• Place the unconnected end of the hose into a bucket and open
the faucet connected to the water supply hose for 10 or 15
seconds to remove any foreign substances from the hose. Close
the faucet before continuing.
• Connect the end of the water supply hose to the water supply intake connection at
the top of the washer.
The hose connected to the COLD water source must be connected to the
COLD water supply intake.
• Tighten the fitting by hand until it is snug, and then tighten them an additional
two-thirds of a turn with a wrench/pliers.
Confirm that the water supply hose is not twisted or bent. If the hose is twisted
or bent, the hose can leak and cause electric shock due to the water leakage.
To ensure correct water usage, connect the COLD water faucet only.
• Turn on the COLD water supply and check all the water supply intake connections
and the faucet for water leaks.
Step 4: Connect the drain hose
Position the other end of the drain hose. It can be
positioned in three ways.
A. Over the edge of a wash basin. Secure the guide
to the side of the basin wall with a hook or to the
tap with a piece of string to prevent the drain
hose from moving.
B. In a standpipe The standpipe must be no shorter
than 32 in. (81cm) and no longer than 39 in. (100cm).
C. In a laundry tub. The laundry tub must be no shorter
than 32 in. (81cm) and no higher than 39 in. (100cm).
Make sure that the connection between the
drain hose and the wash basin, standpipe or
Page 18
laundry tub is not airtight.
Water Inlet Cold Water Source
Connection
Pull down on the white ring
Rubber gasket
to divide the adaptor into
two parts.
Top part: Faucet fitting
Inner threads for outer threaded faucet.
Bottom part: Hose fitting
Outer threads for inner threaded faucet
Connection
Cold
Laundry tub
39 in. Max
32 in. Min
Rubber gasket
Inner threads for o
Outer threads for in
Cold
Cold
Standpipe
Hose
retainer
39 in. Max
Tie
32 in. Min
strap
Hose
retainer
Tie
strap