Introduction; Features; Packaging; Component Identification - VIETA MOBILE VM-BS160BK Manuel De L'utilisateur

Introduction

This Bluetooth wireless speaker system applies the latest BT 3.0 wireless technology platform that enables you
to enjoy music, video everywhere you want.

Features

1. Bluetooth 3.0 Platform
2. Operating distance up to 10 meters / 33 feet (open
area)
3. Powered by 6 x C batteries (not included) or Power
adapter (included)
4. IPX 3 Water-proof feature
5. 3.5mm line in jack

Component identification

1. Power ON/OFF
2. Power LED Indicator
3. Pair
4. Volume -
10
All manuals and user guides at all-guides.com

Packaging

1 x Bluetooth speaker
1 x 3.5 to 3.5mm audio cable
1 x User manual
1 x Power adapter
5. Volume+
6. Power adapter jack
7. 3.5mm audio jack
8. NFC
Bluetooth Wireless Speaker

Pairing

1. Press the power button for 3 seconds to turn the
speaker on, the speaker will enter pairing mode
immediately. The Blue LED light will start flashing
quickly.
2. Enable your Bluetooth device such as cell phones,
tablets or other Bluetooth media, and make sure it is
in searching mode.
3. Select "Vieta BS160" from the list of discovered
Bluetooth devices on your cell phones, tablets or
other Bluetooth media. Wait for the connection to be
completed.
4. Enter "0000" if password is required.
5. Alternatively, you can press the Pair button and
hold for 5 seconds to enter the Pairng mode. In
paring mode, the Blue LED flashes quickly.
6. When Bluetooth connection is made, the Blue LED
will stop flashing.
7. You can now enjoy your music.
Alternatively pairing by One-touch connection
with Near Field Communications (NFC)
1. Press the power button for 3 seconds to turn the
speaker on, the speaker will enter pairing mode
immediately. The Blue LED light will start flashing
quickly.
2. Enable your Bluetooth device such as cell phones,
tablets or other Bluetooth media.
3. Make sure the NFC is enabled in your device.
4. Use your NFC enabled device and touch the NFC
logo on the speaker (as shown in the diagram) , a
"beep" sound indicates pairing is successfully done.
5. When Bluetooth connection is made, the Blue LED
will stop flashing.

Battery Installation

1. Turn the speaker over; on the bottom of the
speaker you will see the battery door.
2. Open the battery door by pinching the two tabs
and pulling towards you.
3. Install 6 (six) C size batteries following the battery
markings inside the compartment.
4. Close the battery door until the door snaps shut.
11 ENGLISH