Bosch Tassimo TAS 65 Série Mode D'emploi page 38

γθ
Problem
χutomatic mode
O
not working, appliance
remains in standάby
modeέ
χutomatic mode
O
skipped, appliance
goes straight to
εanual modeέ
N
The quality of
the crema has
deterioratedέ
ψrewing unit cannot be
securely closedέ
Water dripping from
the brewing unitέ
Water on the surface
under the cup standέ
εore ωustomer Service information is available online at wwwέtassimoέcom
Robert ψosch ώausgeräte ύmbώ
01_TAS 65_85_Heft1.indb 36
Possible!cause
σo T ϊISω insertedέ
The barcode could not be
detectedέ
The barcode could not be
detectedέ
The drink outlet is clogged or
dirtyέ
Piercing unit ή T ϊISω holder is
not properly insertedέ
The T ϊISω is not inserted
properlyέ
The brewing unit is not
properly closedέ
The T ϊISω is damaged or
leakyέ
The piercing unit is either
not inserted or not inserted
properlyέ
Water from condensationέ
Solution
ωheck if T ϊISω has been
insertedέ
ωlean the bar code reading
window and try again or
smooth the barcode on the
T ϊISω out with your thumbέ
Use another T ϊISωέ
If problems persist contact the
TχSSIετ carelineέ
ίκ ίί ίγβ κκ γγ (UK only)έ
ωlean the bar code reading
windowέ
Use another T ϊISωέ
You can still prepare the drink
by holding down the start ή stop
buttonέ
Remove the drink outlet
from the brewing unit and
detach the piercing unitέ
χfter cleaning everything
thoroughly, reassemble the
parts and replace them in the
brewing unitέ
Insert the T ϊISω holder and
piercing unit properlyέ
Reάinsert the T ϊISω and
make sure it is properly
positionedέ
Push the clamp down irmly
until it audibly clicks into placeέ
Stop the brewing process,
remove the T ϊISω and clean
the brewing unitέ
ωheck to ensure that the
piercing unit is inserted
properlyέ
ωondensation may occur and
is not a faultέ Remove it by
wiping with a clothέ
en
09.05.2011 09:32:40