Power Supply Cord; Energy Saving Tips - ArcticAire APA070B1G Guide D'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INFORMATION
POWER SUPPLY
CORD
1) Connect the power supply cord to an
electrical outlet.
2) The power supply cord has two buttons
located on the head of the plug. One button is
marked "TEST", and the other is marked
"RESET". Press the "TEST" button; you will
hear a click as the "RESET" button pops out.
3) Press the "RESET" button; you will hear a
click as the button engages.
4) The power supply cord is now energized
and supplying electricity to the air conditioner
(on some products this is also indicated by a
light on the plug head).
ENERGY-SAVING
TIPS
1) Select a thermostat setting that suits your
comfort needs and leave at that chosen
setting.
2) The air filter is very efficient in removing
airborne particles. Keep the air filter clean at
all times.
3) Use drapes, curtains or shades to keep
direct sunlight from penetrating and heating
room, but do not allow drapes or curtains to
obstruct the air flow around the unit.
The power cord supplied with this air conditioner contains a device
that senses damage to the power cord. To test if your power cord is
working properly, you must do the following:
NOTE: The power cord supplied with this air
conditioner contains a current leakage
detection device designed to reduce the risk
of fire. In the event the power supply cord is
damaged, it cannot be repaired and must be
replaced with a new cord from the product
manufacturer.
• Under no circumstances should this device
be used to turn the unit on or off.
• The "RESET" button must always be
pushed in (engaged) for correct operation.
• The power supply cord must be replaced if
it fails to reset when the "TEST" button is
pushed in.
Your Danby appliance is designed to be highly efficient in
energy savings. Follow these recommendations for greater
efficiency.
4) Start your air conditioner before the
outdoor air becomes hot and uncomfortable,
to avoid an initial period of discomfort while
the unit is cooling off the room. Use of the
automatic start/stop programmable TIMER
feature can be a major asset in this regard if
utilized to the fullest extent.
5) When outdoor temperatures are cool
enough, turn the air conditioner off and use
the FAN MODE. This circulates indoor air,
providing some cooling comfort while utilizing
less electricity.
4

Publicité

Chapitres

Table des Matières
loading

Table des Matières