ZAMST EK-1 Instructions D'utilisation page 2

1.
Place the center of the product at the back of your knee
with the correct side up. Straighten your knee and fasten
the upper hook-and-loop fastener B above your kneecap.
Position of
kneecap
Logo mark
2.
Fasten hook-and-loop fastener C below your kneecap.
Position of
kneecap
3.
Fasten hook-and-loop fastener A.
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer directly. It is only necessary to notify the manufacturer and the competent authority of
the member state in the event of any serious incidents that could lead to a significant deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of
Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Hook-and-loop
fastener B
Hook-and-loop
fastener C
Hook-and-loop
fastener A
4.
Adjust hook-and-loop fasteners A, B, and C so that you
will be able to maintain an appropriate compression force.
5.
For EK-5 Only: Fasten the femoral cross straps at the
back of your thigh.
For EK-5 Only
6.
Pull the product up and down to eliminate slack.
7.
Make sure that the product is not loose or out of place.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
Femoral cross strap