Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 5 fitting brackets
- 4 « silent block » + steel spacer
- 2 BHc 6×25 screws
- 2 Ø6 washers
- 2 Ø5 nylock nuts
- 2 Ø6 nylock nuts
Assembly
- Place the fitting brackets as indicated on photos (the tightening torque wrench of the engine casing's
screws is 0, 8 kg/m²). The 2 front brackets are fixed on the free place with the 2 BHc 6×25 screws, the Ø6
washers and Ø6 nuts.
- Fix the "silent-block" on the belly pan and insert the spacers inside them putting the flange at the
outside.
- Assemble the 2 parts of the belly pan with the 2 BHc 5×15 screws, the 2 plastic washers and the 2 Ø5
nylock nuts, with the remaining bracket (V-shaped). This last one is fixing inside the belly pan.
- Place the belly pan on the motorbike and fit it thanks to the 4 BHc 5×20 screws.
- Aluminium railings are one option. They take place at the air intakes with stick for windshield
(polyurethane stick).
Place the half-part of the belly pan on the motorbike in order to
Once fitted, the belly pan must have no contact with motor and has to be far enough from
complet exhaust system. Fitting brackets' angles may be a little modified in order to adjust the
accessory to every motorbike (do not fold the fixing brackets while fitted on belly pan).
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
Short bracket
Right hand-side brackets
well see the fitting points.
ERMAX BELLY PAN ADAPTABLE ON
675 STREET TRIPLE R 2009 → ∞
Long bracket
Left hand-side brackets
- 4 BHc 5×20 screws
- 3 threaded fasteners
- 2 Ø5 plastic washers
- 2 BHc 5×15 screws
- 2 20×8 cm alu nettings
« CAUTION »
FITTING INSTRUCTIONS
675 STREET TRIPLE 2008 → ∞
Publicité
