Numark NTX1000 Guide D'utilisation page 5

9. Pitch Fader: Move this fader to increase or decrease speed of the platter (and therefore
the pitch of the track). In the center position, the pitch is at 0%. Use the Pitch Range
button to set the full range of the pitch fader.
10. Pitch Range: Press this button to cycle through the available ranges of the pitch fader:
±8%, ±16%, and ±50%. The lights above the button indicate the current selection.
11. Pitch Reset: Press this button to return the speed of the platter to 0% pitch adjustment
immediately, regardless of the position of the pitch fader.
Tonearm
See Setup > Tonearm
12. Tonearm: With the tonearm lever in the "raised" position, gently
move the tonearm so it rests over your record on the platter. To
play your record, move the tonearm lever to the "lowered"
position, which will lower the tonearm onto your record.
13. Tonearm Lock Nut: This nut secures the headshell and cartridge
assembly to the tonearm. Turn the cartridge clockwise to loosen it
or counterclockwise to tighten it. Do not over-tighten it.
14. Headshell: Mount your cartridge (not included) on this headshell,
and then attach the headshell to the tonearm lock nut.
(Remember to remove the plastic cover from your cartridge
before using it.) The headshell is user-replaceable and compatible
with many standard cartridges.
Note: To prevent damage, we recommend removing the
headshell and cartridge assembly before packing or transporting
NTX1000.
15. Tonearm Clip: Close this clip to secure the tonearm while it is not
being used. The clip remains in the "up" position while open.
16. Tonearm Lever: Move this lever between its two positions to
raise or lower the tonearm. Raise the tonearm before moving it
toward or away from the record, and lower it once it is in place.
17. Anti-Skate Dial: Turn this dial to compensate for inward tracking forces that occur with
certain cartridges as the stylus nears the center of the record. In most cases, set this to 0.
If you experience excessive skipping during back-cueing or scratching while nearing the
center of the record, increase this dial's setting in small increments and test its
performance.
18. Height Adjustment & Lock Lever: Turn this large dial to set the height of the tonearm.
Move the small Lock lever (above the Anti-Skate Dial) counterclockwise or clockwise to
unlock or lock the height adjustment, respectively. See
set the appropriate height.
19. Counterweight & Scale Ring: The counterweight balances the headshell and cartridge
assembly so the tonearm can apply the proper amount of stylus pressure to the record.
See Setup > Tonearm
Note: If your headshell is heavier than expected, there is an additional counterweight
included, which you use with this counterweight to balance your tonearm properly.
for additional details on these controls.
to learn how to properly balance the tonearm.
15
Setup > Tonearm
19
18
17
16
12
13
14
to learn how to
5