Shortened Or Extended Combustion Cycle; The Display Of The Electronics - Olsberg OEC Mode D'emploi

Shortened or extended combustion cycle

Since the operation of the stove is primarily dependent
on the downstream chimney, you have the possibility
of reacting to different chimney conditions by choosing
different control curves.
Control curve 1:
→ Extended combustion cycle
→ Use, for example, with increased chimney draught
→ Primary air shuts off after 10 minutes
→ Reduced secondary air supply
→ „Add fuel" signal if temperature drops below 200°C
Control curve 2:
→ Normal combustion cycle (factory setting)
→ Primary air shuts off after 15 minutes
→ „Add fuel" signal if temperature drops below 280°C
Control curve 3:
→ Reduced combustion cycle
→ Use for poor chimney draught
e.g. transition times with increased outside
temperatures
→ Primary air shuts off after 20 minutes
→ Increased secondary air supply
→ „Add fuel" signal if temperature drops below 280°C
Control curve 4:
→ Specific combustion cycle
→ Use with water appliances, Tolima PowerSystem
and stoves with admixed air mechanism
→ Primary air shuts off after 20 minutes
→ Increased secondary air supply
→ „Add fuel" signal if temperature drops below 200°C
Control curve 5:
→ Normal combustion cycle
→ Use with Tenorio PowerSystem, Pacaya
→ Primary air shuts off after 15 minutes
→ „Add fuel" signal if temperature drops below 200°C
Attention:
→ Control curve 4 must be set with
- stoves with water technology
- stoves with admixed air mechanism
- Tolima Power System
→ Control curve 5 must be set with
- Tenorio Power System
- Pacaya
Furthermore, there is the possibility of setting the shut-
off time of the primary air in a range of 1 to 60 minutes
for the electronics in the operator menu.

The display of the electronics

Indicates automatic mode
→ Illuminates in intervals
Indicates manual mode
→ Illuminates in intervals
Indicates air regulator setting is 100% open
Indicates a fire chamber temperature of 380°C
→ Select the fire chamber temperature or air regulator
setting display using the P or M buttons
Press P or M → t-1 → 380 (380°C)
Press P or M → S-1→ 100 (100%)
31