Cleaning And Maintenance - AUROM Force Ashcleaner 161410 Mode D'emploi

Description
1. Handle
2. Cap (with motor)
3. Lock (2x)
4. ON/OFF – switch (I/O)
5. Barrel
6. Connection hose
7. Fire prevention HEPA filter
Standard accessories:
 Hose (1,2 m)
 Aluminum tube (20 cm) to suck
ash from fireplaces etc.
 Crevice tool
Operation
 Remove the packaging materials and keep out of the reach of children. After
removing packaging, check device for damage or any evidence that may point to
a defect/failure. If in doubt, do not use the device but refer to your supplier for
checks/repairs.
 Insert the hose as far as it will go into the hose connector: you may turn it until
the catch falls into the recess. Then turn it a quarter clockwise.
 After this, connect the accessories you wish with a twisting force.
 Insert the plug into the socket.
 Press the ON-switch (I) to turn on (and press later on the off-switch (O) to turn
off).
 The device is suitable for vacuuming cold ash from open fireplaces, wood or coal
burners, ashtrays, grills and so on. Never vacuum ashes that are hotter than
40°C! Cold ash has been given sufficient time to cool down and contains no
glowing cinders, residues or objects which could still be burning; check that this
is the case before you clean up the ash! Cold ash does not emit any heat. Only
vacuum ash that has been created by regular fuels.
 Do not use without filter in place.
Note: the filter must fully press the white switch on the engine block otherwise the
device will not work!

Cleaning and maintenance

Before cleaning or maintenance: always switch off the equipment and unplug it.
Emptying barrel
Open both the locking blocks en take the up housing from the vacuum cleaner.
Remove the dirt out of the barrel and clean the barrel. If you have to use water for
18