Grounding Instructions - HoMedics DEEP SOAK DUO Guide D'utilisation

GROUNDING INSTRUCTIONS

Tab for
Grounding
Grounding Pin
Adapter
Screw
Figure A Figure B
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of
least resistance for the electric current to reduce the risk of electric shock. This product is equipped with
a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed and grounded in accordance with all local codes and
ordinances.
DANGER
Improper connection of the equipment-grounding conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in doubt as to whether the product is
properly grounded. Do not modify the plug provided with the product - if it will not fit the outlet, you
may temporarily use an adapter (such as the one shown in Figure B) until you have a proper outlet
(such as the one shown in Figure C) installed by a qualified electrician.
This product is for use on a nominal 120-volt circuit, and has a grounding plug that looks like the plug
illustrated in Figure A. A temporary adapter that looks like the adapter illustrated in Figure B may be
used to connect this plug to a 2-pole receptacle as shown in Figure D if a properly grounded outlet is not
available. The temporary adapter should be used only until a properly grounded outlet Figure C can be
installed by a qualified electrician. The tab for grounding screw Figure B extending from the adapter must
be connected to a permanent ground such as a properly grounded outlet box cover. Whenever the adapter
is used, it must be held in place by a metal screw. See Figures D and E.
Grounded
Outlet
Metal Screw
Figure C Figure D Figure E
4
DEEP SOAK DUO FOOTBATH
™
• Heat Boost Power heats water to warm spa temperature in minutes and maintains temperature
™
throughout use.
• Easy controls to select Poweroll Massage, Waterfall Jets, Heat Boost Power
™
Adjustable Temperature.
• Raised nodes in floor manually massage feet.
• Poweroll ™ Massage lets you enjoy a relaxing massage with or without water.
INSTRUCTIONS FOR USE
1. Ensure that the unit is unplugged before filling with water. Fill with water to the fill line located on
the inside of the tub. For a quicker Heat Boost, fill with warm water. Once water reaches selected
temperature, it will stay at this temperature for as long as heat function is selected.
2. Plug the unit into a 120-volt household outlet.
3. Sit down in a comfortable position. Press Power, then select your desired feature by pressing the
corresponding button. Press once to turn feature on. Press again to turn feature off (Fig. 1). Note: The
unit is equipped with a 30 minute auto shut-off.
a. To select a wet or dry foot massage, press Rollers button to start PoweRoll
b. To heat up the water with Heat Boost Power
will illuminate when selected and soothing waterfall jets will turn on.
c. To adjust the water temperature, press +/– arrows to increase and decrease the thermostat.
Note: Always test water temperature before fully submerging feet into water.
4. To empty, first unplug the unit. Take footbath to closest drain and tip unit, allowing water to pour out
along the back heel area where the drain spout is located. DO NOT pour water over the control panel.
Caution: To avoid injury and irreparable damage, always remain seated when using this footbath.
Never stand on or in the unit.
and
™
massage.
™
™ press the Waterfall + Heat button. The button
5