Switch Trigger; Variable Speed - GreenWorks CD24B00 Manuel D'utilisation

Masquer les pouces Voir aussi pour CD24B00:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION
To remove:
■ Depress the latch on the battery pack.
■ Remove the battery pack from the drill.
W A R N I N G
Always remove battery pack from your tool when you are assembling parts, making adjustments, cleaning, or when not
in use. Removing battery pack will prevent accidental starting that could cause serious personal injury.
W A R N I N G
Battery products are always in operating condition. Therefore, the switch should always be locked when not in use or
carrying at your side.

SWITCH TRIGGER

Fig. 3
Direction of rotation selector
Reverse
Switch trigger
Forward

VARIABLE SPEED

The variable speed switch trigger delivers higher speed with increased trigger pressure and lower speed with
decreased trigger pressure.
NOTE: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal
part of the switch function.
DIRECTION OF ROTATION SELECTOR (FORWARD/REVERSE/CENTER LOCK)
The direction of bit rotation is reversible and is controlled by a selector located above the switch trigger. With the drill
held in normal operating position, the direction of rotation selector should be positioned to the left of the switch trigger
for forward drilling. The drilling direction is reversed when the selector is to the right of the switch trigger.
Setting the direction of rotation selector in the OFF (center lock) position helps reduce the possibility of accidental
starting when not in use.
To stop the drill, release the switch trigger and allow the chuck to come to a complete stop.
C A U T I O N
To prevent gear damage, always allow the chuck to come to a complete stop before changing the direction of rotation.
NOTE: The drill will not run unless the direction of rotation selector is pushed fully to the left or right.
Avoid running the drill at low speeds for extended periods of time. Running at low speeds under constant usage may
cause the drill to become overheated. If this occurs, cool the drill by running it without a load and at full speed.
To turn the drill ON, depress the
switch trigger. To turn it OFF,
release the switch trigger.
10

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

709992

Table des Matières