C - Installation; Wiring; Connecting The Videophone (Monitor, Intercom Panel And Camera); Connecting An Electric Strike Plate Or Lock - THOMSON 512263 Mode D'emploi

C - INSTALLATION

Tips and important notes:
• In order to make the most of your intercom
panel, we advise you to configure it (loudspeaker
volume) before it is installed in its final location.
To do this, you will need to connect it on a table,
to ensure that the settings have been configured
correctly.
• If you test your product before installing it, please
do not do this with the intercom panel
and the monitor in the same room, to avoid the
emission of a high-pitched sound (Larsen effect).
• Do not expose the camera directly to the sun or
facing a reflective surface.
• Tip: it is recommended for the wires to be
covered by a sheath to protect them from bumps
and the weather.

1. WIRING

To avoid the risks of interference and malfunction,
do not pass the wire for your videophone through
the same sheath as that housing the electrical
wires (230V - 50Hz). Each cable connecting the
monitor and the intercom panel must be a single
part. Avoid joints (insulating screw joints, soldered
joints, etc.)
Note: Do not under any circumstances double
wires to increase the wire size.
1.1. Connecting the videophone (screen,
intercom panel and camera, see fig. 1, fig. 2)
• Ensure proper connection of the wires,
following one of the wiring diagrams depending
on the desired configuration.
• Take careful note of the label affixed to the
front of the smart device and at the back of the
intercom panel.
• Depending on the selected configuration,
configure your monitor as a "Master" or "Slave".
You can adjust this setting through the settings
management menu of your monitor.
1.2. Wiring gate automation
• The intercom panel provides a dry-contact
connection, without an electric current, to
be connected to the control button for your
automated gate.
• Connect it directly to the terminals identified on
10
EN
m c o n . s o m o h y t m w . w w
the description of the intercom panel (Section 4
- Intercom panel) at the back of the board (no
polarity to follow).
• The opening function can only be used if the
respective intercom panel video is displayed.
1.3. Connecting an electric strike plate or
lock
Important: The electric strike plate or lock that
you install must be equipped with a mechanical
memory. The power supply to the lock must not
exceed 12V/1.1A.
• Connect it directly to the terminals identified on
the description of the intercom panel (Section 4
- Intercom panel) at the back of the board (no
polarity to follow).
• The opening function from the monitor can
only be used if the respective intercom panel
video is displayed.
2. CONFIGURATION OF THE INTERCOM PANEL (SEE
FIG. 1, FIG. 2)
2.1. Intercom volume setting:
Setting the volume of the intercom and
conversation volume can be done from the
settings interface on the video intercom screen.
More details are available in Section D - Use.

2.2. Configuration of the RFID function:

The RFID function enables opening to be
managed using badges from the intercom
panel, even when the screen is switched off.
2.2.1 Programming
administrator badges:
The first time these are activated, it is imperative
for the badges to be configured in the following
order:
1. Press the reset button at the back of the
intercom panel for 5 seconds, the intercom
panel emits 6 short beeps.
2. Swipe the administrator badge (yellow),
a short beep confirms that it has been
programmed.
3. Swipe the + badge (blue), a short beep
confirms that it has been programmed.
COLOUR VIDEO INTERCOM
(or resetting) of