Philips FC6125 Mode D'emploi page 10

English
10
Cleaning the roller brush
1 Switch off the appliance before you clean the roller brush.
 Remove the transparent front cover from the sweeper base. Grab
the bottom edge of the cover with both hands, pull it outwards (1)
and upwards (2) firmly until it is released from the slots (Fig. 16).
 Rotate the roller brush until the cutting groove faces you. Use a
pair of scissors to cut the hairs, threads etc that have collected
around the roller brush (Fig. 17).
 Remove fluff, hairs and other dirt from the roller brush.
Removing the roller brush
1 To remove the stick, press the button on the lower handle (1) and
pull the stick upwards () (Fig. 5).
 Turn the sweeper base upside down, push the release slide in the
direction of the arrow (1) and remove the retainer (2) (Fig. 18).
 Slip the belt off the end of the roller brush (1) and lift the brush
out of the base () (Fig. 19).
 Remove fluff, hairs and other dirt from the roller brush and the
groove.
Reinserting the roller brush
1 Slip the belt over the ribbed end of the roller brush. Insert the
other end of the roller brush into the slot opposite the
belt (Fig. 0).
 Insert the end of the roller brush with the belt into the other
slot. (Fig. 1)
Do not force the roller brush into the slot. Rotate the roller brush so
that the ridge on the side with the belt points upwards.
 Put the retainer back into the slot (1) and slide the release slide to
the original position ('click') (2) (Fig. 22)