Important Safeguards - Water Tech 11A0060 Manuel De L'opérateur

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

For Bottom Cleaning

Press the ON/OFF button on the battery box to start the Leaf

Vac. Using the pool pole, lift the Leaf Vac into the pool and

guide it to the pool bottom in the "Wheels Down" position.

For Surface Cleaning

Push the pole adapter down

until the adapter locks in place.

Turn the cleaner "ON."

The Leaf Vac may now be used

in the "Wheels Up" position to

skim leaves and other floating

debris from the pool's surface.

Adjusting the Clearance Height

The Leaf Vac is packaged

with its clearance height in the

"LOW" position.

The height of the Leaf Vac

can be raised up to 1/4 inch if

needed by doing the following:

1. Use a small scewdriver or

pair of needle-nose pliers to

remove the "E"-clip from the

top of the wheel pivot shaft.

2. Remove the wheel pivot

shaft assembly. Don't lose the

"E" - clip and spacer.

(see Photo).

3. Place the spacer on the

pivot shaft and guide the

shaft back into the body from

beneath.

4. Replace the "E"-clip on the

top of the shaft.

Repeat these procedures on

the remaining 2 wheel pivot

assemblies.

USING THE VOLT LEAF VAC

Maintenance

ALWAYS clean out the debris bag following each use and

carefully remove any debris that might be stuck in the

propeller area of the cleaner.

Remove the batteries from the battery box prior to long-term

storage (ie. at the end of the pool season).

1. Extreme care must be taken to avoid fingers,

toes, hair or any other body part from coming in

contact with the Impeller while the unit is

operating.

2. Operation of this unit by children and/or

persons of diminished physical or mental

capacity is not recommended unless they are

closely supervised by an authorized adult.

3. Always check the battery box cap to make

sure that it is completely closed before each

use. If water enters the battery box, it can

damage the unit but is not considered a health

hazard.

Pole Adapter Assembly

P11A061LV

Battery Chamber Assembly

P11A015LV