Installation - KINTERA KHP12 Manuel D'installation Et Mode D'emploi

UNPACKING
Unpack the Open Burner immediately after receipt. Remove the Gas Open Burner from the crate; remove all
packaging on and surrounding the unit and be certain to remove all protective plastics and residues from all
surfaces. Make sure that all parts provided including the L.P. gas conversion kit are located. Equipment must
have the legs properly installed before use. Before using this equipment it must be cleaned and dried
thoroughly.

INSTALLATION

NOTE: It is vital that the purchaser of this equipment post in a prominent location instructions to be followed in
the event that the user smells gas. This information shall be obtained by consulting the local gas supplier. The
purchaser of this equipment must post in a prominent location.
1. Read this manual thoroughly before installation and operation. DO NOT proceed with installation and
operation if you have any questions or do not understand anything in this manual. Contact your local
representative or Kintera first.
2. Select a location for the Open Burner that has a level, solid, nonskid surface that is nonflammable and
away from water hazards or sinks, and is in a well-lighted work area away from children and visitors.
3. This equipment but be installed under a proper ventilation as required by local code.
Local codes regarding installation and ventilation vary greatly by area. The
National Fire Protection Association states in its NFPA 96 latest edition (see NFPA page at the
beginning of this manual) that local codes are "authority having jurisdiction" when it comes to
requirements for installation of equipment. Therefore, installation should comply with all local
codes.
4. Screw legs into (A) the permanently fastened nuts on the four corners of the unit and tighten by hand.
Legs must be installed to adequately provide proper ventilation to the unit. (See Figure 1)
5. Level unit by adjusting the four feet and tighten securely. The adjustable feet have an adjustment of
one inch. Do not slide unit with legs mounted, lift if necessary to move unit.
6. The supplied gas pressure regulator is factory set at 4" Natural Gas W.C. or 10" Propane Gas
7. THESE UNITS ARE SUITABLE FOR INSTALLATION ON NON-COMBUSTIBLE SURFACE ONLY.
Noncombustible clearances: 6" sides (152 mm), 6" rear (152 mm), 4" floor (102 mm).
8. Do not obstruct the flow of combustion and ventilation air under the unit by the legs or behind the unit
by the flue. Do not place objects between the bottom of the unit and the counter top.
9. There must be adequate clearance for removal of the front panel. All major parts except the burners
are removable through the front if the gas is disconnected.
10. It may be necessary to adjust the balance of gas volume and air supply to each burner. This must be
done by and authorized service technician.
11. Pipe threading compound must be resistant to the action of liquefied petroleum gas. DO NOT USE
TEFLON TAPE.
DO NOT use an open flame to check for leaks. Check all gas piping for leaks with a
soap and water solution before operating the unit.
The installation of this appliance must conform to local codes, or In the absence of local codes, the
National Fuel Gas Code, ANSI Z223.1/NFPA 54, or the Natural Gas and Propane Installation Code, CSA
B149.1, as applicable.

The appliance and its individual shut off valve must be disconnected from the gas supply piping
system during any pressure testing of that system at test pressures in excess of ½ PSI (3.5kPa)

The appliance must be isolated from the gas supply piping system by closing its individual manual shut
off valve during any pressure testing of the gas supply piping system at test pressures equal to less
than ½ PSI (3.5kPa).
Clearance and positioning around the appliance: This appliance must be installed adjacent to
non-combustible surfaces only with a minimum spacing of six (6") inches from all sides. This appliance must
PHP Owner's/Installer Manual Rev 20180822
5
For Warranty Service Call 866-909-2855