Troubleshooting Guide - Coxreels SDH Série Manuel D'installation Et D'entretien

TROUBLE
HOSE/CABLE WILL NOT FULLY FIT ON TO
DRUM OF REEL
REEL KEEPS TURNING WHEN OPERATOR
STOPS PULLING OUT HOSE/CABLE.
NO ELECTRICAL CURRENT AT OUTPUT
END OF CABLE.
(1125WC SERIES ONLY)
DRUM OF REEL IS CRUSHED OR
DAMAGED.
FLUID PATH (PLUMBING AND/OR SWIVEL)
IS LEAKING OR DAMAGED.
FLUID LEAKS FROM SWIVEL
SWIVEL ASSEMBLY IN NOT MOVING
FREELY OR LOCKING UP
For assembly drawings, parts lists, or specific repair instructions, refer to web site at
INSTALLATION AND MAINTENANCE MANUAL
FIGURE 4.0 (112, 117, CM & DM
TROUBLE SHOOTING GUIDE
CAUSE
a) Hose/cable is longer than specified.
b) Outside diameter of hose is larger than
specification.
c) Hose/cable was not hand guided onto reel and
wound up evenly on drum.
Tension drag brake is too loose causing
hose/cable backlash.
a) Cable is severed.
b) Slip ring brushes are worn.
Hose was not charged when initially installed on to
reel.
a) Maximum pressure rating for reel has been
exceeded.
b) Application is not compatible with plumbing
and/or swivel seal materials.
Swivel seals are damaged or worn.
a) Inlet hose fitting has been over-tightened
b) Inlet hose is not flexible causing side force on
swivel.
Coxreels, Inc., 5865 S. Ash Ave., Tempe, Arizona, USA, 85283
REMEDY
a) Cut down hose/cable to meet reels specified capacity.
b) Replace hose with a hose that meets the specified maximum
outside diameter requirements.
c) Hand guide hose/cable on to drum to wrap evenly as it is wound
on to the reel.
Adjust tension drag brake by turning fastener clockwise.
a) Replace cable.
b) Replace slip ring brushes.
Note: Ensure current does not exceed rated amperage.
Replace damaged drum. Contact factory.
Install hose per instructions.
a) Replace or repair damaged components. Consult factory. Check
maximum pressure rating of reel.
b) Contact factory to determine chemical compatibility or
environmental issues (i.e. temperature rating).
Replace swivel seals. See "Swivel Seal Replacement".
Caution: Be sure leak is not at Hose Fitting!
Remove and examine swivel assembly for damage. Replace as
necessary.
Properly tighten inlet hose. Hand tighten fitting, plus ½ turn with
wrench.
Page 4 of 4
www.coxreels.com
Tel: 1-800-269-7335
FORM #PM-003 REV E 09/13
or consult factory.