EMAG Emmi 04D Mode D'emploi page 13

the cleaning time by 1 minute (maximum 9 minutes). The cleaning time to be set depends on the
degree of contamination of the objects to be cleaned. When the set cleaning time has expired,
the digital time display will show „0" and the unit will stop the cleaning process automatically.
If you wish to stop the equipment earlier please push the OFF switch. The tub is portable and
makes it easier to fill and empty the tub with water. After the completion of the cleaning process,
remove the cleaned items from the tub and rinse briefly under running water to remove any
remaining dirt particles. After the completion of the cleaning process (or several cleaning proces-
ses) it is recommended to remove the water from the tub, rinse the tub briefly and wipe dry with
a cloth. Please make sure that no water enters the housing through the ventilation slots in the
bottom of the unit.
Note:
Please take into account a degassing time when filling fresh water depending on the
degree of hardness. In order to degas the water, we recommend that the device be run with filled
water for a few minutes before putting the objects in.
Emmi 04D
Fill tank with tap water to just below the MAX mark. Plug the power cord into the power socket.
For thorough and optimal cleaning of the items, we recommend the use of the respective EMAG
cleaning concentrates (see sect. 7 cleaning accessories). Place the contaminated objects in the
plastic basket and place them in the tub filled with water. To switch on the device, press the ON/
OFF button, then use the Timer to set the cleaning time required. Time needed depends on the
degree of contamination of the objects. (Adjustment times 1/3/5/7/9 Minutes) After the desired
cleaning time has elapsed, remove the cleaned material with the basket from the tub and rinse
under running water. The device will now show the "0" position. If you are done with the unit,
unplug the power cord. The STANDBY indicator light, by function, goes out when the unit is swit-
ched off. If the unit is not to be used for an extended period of time, it is recommended to empty
the tub and dry it with a cloth.
Emmi D21
Fill the tub with tap water between the marking ranges MIN±MAX. It should be noted that the
cleaning objects must be completely covered with water. Plug the power cord into the power
socket. For thorough and optimal cleaning of the items, we recommend the use of the respective
EMAG cleaning concentrates (see sect. 7 cleaning accessories). Place the contaminated objects
in the plastic basket and place them in the tub filled with water (See note below). To switch on
the device, press the START/STOP button, then adjust the cleaning time (5-10-15 Min.). Then the
operating lamp lights up on the Display. If the heating is to be switched on, press the heating
control button. The heater can only be operated in parallel with the ultrasonic function! The
water then heats up and switches off automatically when the maximum temperature of 60°C is
reached. For safety, due to overheating, the heater switches off automatically after 45 minutes of
starting. Should overheating occur, the overheating lamp will light up red and you should unplug
the power cord to turn off the unit. After completion of the cleaning process, remove the cleaned
item(s) from the tub and rinse briefly under running water. If the unit is no longer to be used,
unplug the power cord and the STANDBY indicator will turn off automatically. If the unit is not
to be used for an extended period of time, it is recommended to empty the tub and dry it with a
cloth.
Emmi 07D
Fill tank with tap water to just below the groove. Plug the power cord into the power socket. For
thorough and optimal cleaning of the items, we recommend the use of the respective EMAG
cleaning concentrates (see sect. 7 cleaning accessories). Place the contaminated objects in the
basket and place them in the tub filled with water. To switch on the device, press the ON/OFF but-
ton, then use the Timer to set the cleaning time required. Time needed depends on the degree
of contamination of the objects. (Adjustment times 1-4 Minutes) After the desired cleaning time
has elapsed, remove the cleaned material with the basket from the tub and rinse under running
water. If you are done with the unit, unplug the power cord. If the unit is not to be used for an
extended period of time, it is recommended to empty the tub and dry it with a cloth.
13