Initial Operation; Online Registration; System Requirements - Behringer U-CONTROL UCA222 Manuel D'utilisation

24 U-CONTROL UCA222 User Manual

1.2 Initial operation

Please make sure the unit is provided with sufficient
ventilation, and never place the UCA222 on top of an amplifier
or in the vicinity of a heater to avoid the risk of overheating.
The current supply is made via the USB connecting cable,
so that there is no external power supply unit required.
Please adhere to all required safety precautions.

1.3 Online registration

Please register your new Behringer equipment right after your
purchase by visiting http://behringer.com and read the terms
and conditions of our warranty carefully.
Should your Behringer product malfunction, it is our intention
to have it repaired as quickly as possible. To arrange for
warranty service, please contact the Behringer retailer from
whom the equipment was purchased. Should your Behringer
dealer not be located in your vicinity, you may directly contact
one of our subsidiaries. Corresponding contact information is
included in the original equipment packaging (Global Contact
Information/European Contact Information). Should your
country not be listed, please contact the distributor nearest
you. A list of distributors can be found in the support area of
our website (http://behringer.com).
Registering your purchase and equipment with us helps us
process your repair claims more quickly and efficiently.
Thank you for your cooperation!

2. System Requirements

The UCA222 is PC and Mac-compatible. Therefore, no installation
procedure or drivers are required for the correct functioning of
the UCA222.
To work with the UCA222, your computer must fulfill the
following minimum requirements:
PC PC
Intel or AMD CPU, 400 MHz or higher G3, 300 MHz or higher
Minimum 128 MB RAM
USB 1.1 interface
Windows XP, 2000
2.1 Hardware connection
Use the USB connecting cable to connect the unit to your
computer. The USB connection also supplies the UCA222 with
current. You can connect a variety of devices and equipment to
the inputs and outputs.
Mac
Minimum 128 MB RAM
USB 1.1 interface
Mac OS 9.0.4 or higher,
10.X or higher