Figure 10 Custom #1 And #2 Options; Shock Protocol Options; Figure 10 - Medtronic LIFEPAK CR–T AED Mode D'emploi

Shock Protocol Options

Table 8
Button Shock Protocol
F1 Fixed #1
F2 Fixed #2
F3 Fixed #3
F4 Fixed #4
C1 Custom #1
C2 Custom #2
* = Shock (Green) = No Shock (Red)
Configuring Shock Protocols
You can change the Custom #1 and Custom #2 shock protocols to any configuration of
prompts, up to nine selections.
NO SHOCK ADVISED
To change Custom #1 and Custom #2 shock protocols:
1 Press the
GREEN SELECT
2 Press either the
MOTION
3 Press the
UP ARROW
no shock.
4 Press the
RIGHT ARROW
select shock or no shock.
5 Repeat Step 4 until you have set the scenario you want to demonstrate and then press the
button until remaining LED bars turn blank.
ARROW
6 Press the
GREEN SELECT
has been saved. The Trainer enters simulated OFF status.
Figure 10 shows the LED displaying the following shock protocol: Bar 1, no shock (red); Bar 2, shock
(green); Bar 3, no shock (red); Bar 4, shock (green); Bar 5, end scenario (blank).
Bar Number 1 2 3 4 5 6 7 8 9 0
Custom #1 and #2 Options

Figure 10

LIFEPAK CR–T Trainer Operating Instructions
©2002-2006 Medtronic Emergency Response Systems, Inc.
SETUP
Order
SNNN
SSNN
NSNN
NNNN
SSSSSSSSS
NNNNNNNNN
= End Scenario (Blank)
button.
button (C1) for Custom #1 or the
button to select shock or no shock. The first bar can be set only to shock or
button to advance to the next bar and press the
button to save the change. The signal sensor flashes, indicating the change
LED Display*
1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0
SHOCK
button (C2) for Custom #2.
PAUSE
UP ARROW
and
button to
UP
19