Troubleshooting; Table: Malfunctions And Possible Causes - NOVARDEN NRL630 Mode D'emploi

EN

Troubleshooting

Table:
Malfunctions and possible causes
Problems
You have entered the
correct PIN code but
the robot mower will
not start.
The battery does not
charge
The robot mower
does not reach the
edge
Possible causes
1. The perimeter cable
is not correctly
connected to the
charging station
2. The perimeter cable
has been cut.
3. There is no power.
Poor communication
between the charging
station and the robot
mower.
4. The robot mower
is away from its
charging station and
is off.
1. The charging station
is not switched on.
2. The battery life is
reduced.
There is an obstacle along
the edge.
16
Solutions
1. Check that the indicator
light is green and that
the perimeter cable is
connected.
2. Connect the perimeter
cable to the charging
station's left and right
terminals.
3. Check the mains supply
and make sure the
cable is connected to
the charging station
correctly.
4. Put the robot back on its
charging station and try
again.
1. Check that the power
cable is plugged in
correctly.
2. If the problem persists,
contact the NOVARDEN
after-sales service.
Check the perimeter cable's
positioning and make sure
there are no obstacles.