English - Philips Avent SCF283 Mode D'emploi

ENGLISH

8
Two large Philips AVENT feeding bottles (330ml/11oz)
1 Insert the rim of the bottles into the slots for large bottles (Fig. 11).
2 Place the teats in the teat cavities (Fig. 12).
3 Place the screw rings loosely on top of the teats (Fig. 13).
Note: Larger screw rings only fit if placed in slanted position over the teats.
4 Place the dome caps in the dome cap holders (Fig. 14).
Four Philips AVENT storage cups and lids
1 Place the storage cups upside down in the basket (Fig. 15).
2 Place the lids vertically around the bottles. (Fig. 16)
Two Philips AVENT breast pumps and two Philips AVENT feeding bottles
Do not place the electrical parts in the steriliser.
1 Fully disassemble the breast pump.
2 Insert the rim of the pump body in the breast pump slots in the bottom of the
basket (Fig. 17).
3 Place the bottles upside down in the bottle cavities (Fig. 18).
4 Place the remaining non-electrical parts of the breast pump in any unobstructed space in
the basket (Fig. 19).
Note: Make sure steam can circulate around these parts.
Using the microwave steriliser
Only place items in the steriliser that are suitable for sterilising. Do not sterilise your bottle
brush or items that are filled with liquid, e.g. teethers filled with cooling fluid.
Note: Before you sterilise bottles and other items, clean them first.
1 Remove the basket from the base.
2 Fill a baby bottle or measuring cup with exactly 200ml tap water and pour this into the
base (Fig. 2).
The amount of water needs to be exactly 200ml. When the base contains too much water, the
items will not be sterilised properly. When the base does not contain enough water, this can
cause damage to the steriliser or microwave.
3 Place the basket in the base (Fig. 3).
4 Place the items to be sterilised in the basket (see chapter 'Preparing for use').
5 Put the lid on the steriliser (1) and push down the clips to lock the lid into place (2) (Fig. 4).
6 Place the steriliser in the microwave. (Fig. 5)
Note: Make sure that the microwave is clean and dry before you start sterilising.
7 Select the appropriate microwave wattage and time (see table below) and let the
microwave operate.