3.2.2 CLW-50 Combustible Wall Finish
•
Figure 3.5 shows installation of combustible wall finish up to 1"
thick. This combustible material goes on any required non-
combustible materials as shown in Figure 3.1 on page 14.
•
This 1" (25mm) combustible material is able to go down to the
fireplace finishing edge.
•
See Figure 3.4 on page 16 for up to 1" (25mm) thick
combustible material installation around the KZK air discharge
grille.
Non-combustible zone
Combustible wall nish
up to 1" (25mm) thick
may be installed over
cement board
Non-combustible
material
Finishing Edge
Figure 3.5, #KZK-1510A Combustible Wall Finish for CLW-50
Komfort Zone Kit #KZK-1510A R.4
CLW-50
½
" (13mm) clearance
around pipe
Steel
Framing
Fireplace Enclosure Floor
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FACING AND FINISHING 17