Faber BASKET Mode D'emploi page 30

Troubleshooting
Symptom
The flame effect
will not start.
The flame effect is
too low.
Unpleasant smell
when unit is used.
Main lamps are
not working and
there are no
flames or smoke.
Cause
Mains plug is not plugged in.
Low water level.
Low voltage connector not connected
properly. (See Fig.5)
The Transducer Unit is not sitting
correctly in the sump
The Metal Disc in the transducer
might be dirty.
The wire from the Transducer Unit is
sitting over the metal disc
Dirty or stale water.
Using unfiltered tap water.
There is no water in the water tank
Corrective Action
Check plug is connected to wall
socket correctly.
Check that the water tank is full and
there is water in the sump.
Check that the connector is inserted
correctly. (See Fig.5)
Ensure the Transducer in sitting down
into the moulded recess in the sump
Clean the Metal Disc with soft brush
supplied. See 'Maintenance.' for a
step by step procedure.
Direct the wire to the back of the
sump and make sure it sits into the
side slot exiting the sump.
Clean the unit as described under
maintenance.
Use only filtered tap water.
Follow instructions under
Maintenance, 'Filling the water tank'.
Check the plug is connected to the
wall socket correctly and that Switch
'A' Fig. 3 is in the 'ON' ( I ) position.
28