"Stop" Function - Ibx WB01 Mode D'emploi

All the water baths, except TWBA-001-001 series, have a draining system, which includes a
pump and a drainpipe.
▪ Before draining, male sure the ON/OFF switch is in the OFF position (O); otherwise, the
resistor could be functioning once the bath has been emptied and get damaged.
▪ With the equipment plugged, press the drain switch; the drainpipe will start emptying the
water bath container.
6.5. Autosetting
The autosetting function allows you to adjust the internal parameters at a certain working
temperature. To do that:
▪ Select the working temperature (follow instructions in 6.1).
▪ Press ▼ until the AT indicatior starts flashing (Green) –you just selected the autosetting
function.
▪ The autosetting will end once the AT indicator turns off.
▪ After the autosetting, the equipment will optimize its service.

6.6. "Stop" Function

The "Stop" function allows you to stop and resume the equipment throughout the execution of
a function. Through this function, you can stop and resume the equipment while heating and if
the timer is on, you can stop and resume it.
▪ In the initial screen, press ▲ for a few seconds. You will hear a "click" and the SV screen will
display "Stop".
▪ To resume the function, press ▲ for a few seconds again until you hear a light beep that
indicates the resumption.
7. Fault Resolution
▪ The equipment cannot be turned ON
Check whether the power cable is plugged in.
-
Make sure the cable is rightly connected.
-
▪ The temperature cannot reach the set point
Check for apparent damages that may have arisen during transportation
-
The resistor and/or the electric system may be damaged.
-
▪ Error E-1:
The bath makes a sound and this error appears on the screen when it does not detect
-
the presence of water. If only deionized water is used, the bath sensor will not detect
the water, so tap water must be added until the sensor detects the water presence.
If these faults are not resolved, contact your manufacturer/supplier.
9