Ribiland Pila50 Manuel D'instructions Et D'utilisation page 22

V. OPERATION
5.1- Intended use
This product is intended for private use.
This product is intended for the pulverization of chemicals on plants.
It should only be used for the dispersion of phyto products, pesticides, herbicides and liquid fertilizers,
authorized and available in the specialized shops.
Always observe the instructions of the manufacturer of the liquid product.
Do not disperse other products with this sprayer.
Any other use different from that stated in this manual can cause damage to the product and present serious
danger to the user
Do not use the sprayer for any other use, such as spraying varnish!
Any unauthorized use releases the manufacturer from all liability.
REMINDER
Keep people and animals away from the work area.
Never spray towards people, animals or objects that can be damaged.
Remember that the high-speed output nozzle spray can throw objects violently which could become a source
of danger. The user is solely responsible for the dangers and damage occurring to third persons or property.
5.2- Starting and stopping the sprayer (Fig.5)
(a) Charging inlet
(b) Switch positions:
0 : OFF
I : ON (pressure 3 bars)
II : ON (pressure adjustable 0-3 bar)
(c) Pressure controller (knob allowing adjusting the working pressure
5.2.1- Starting the sprayer
To start the sprayer: set switch in position I.
Note: the sprayer features on demand operation. This means that once the power is switched on, simply
squeeze the trigger to begin spraying, and release the trigger to stop.
ATTENION! When the tank runs out of liquid, the pump will continue to run even though the trigger is
closed, because the pump is not making enough pressure to activate the switch. When this occurs simply
switch off the pump (set switch on 0 position).
Tips:
Always point the wand and spray nozzle towards the working area, then press the trigger (Fig.6) and the
spray flow will begin.
Simply release the trigger to stop the spray operation.
The trigger features a locking mechanism that allows the handle to be locked in the on position, helping to
reduce operator fatigue.
For maximum pump life, the recommended duty cycle of pump operation is one minute "on" and one
minute "off".
With this in mind it is recommended that the operator avoids running the pump continuously for more than
one minute with the trigger in the locked position.
You can adjust the spray pattern (Fig.6) by rotating the nozzle tip.