Chauvet Scorpion Scan 3D EU Guide Rapide page 7

4. S
ETUP
AC Power
Fuse Replacement
Mounting
Orientation
The Scorpion™ Scan 3D EU has an auto-ranging power supply and it can work with an input voltage
range of 100~240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and wiring), use the
current value listed on the label affixed to the product's back panel, or refer to the product's
specifications chart. The listed current rating indicates the product's average current draw under
normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0~100% switch.
If the power input cord that came with your product has no plug or you need to change the plug, use
the table to wire the new plug:
Cable (EU)
Brown
Light Blue
Yellow/Green
Disconnect the product from power before replacing the fuse.
1. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
2. Pry the fuse holder out of the housing.
3. Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.
4. Insert the fuse holder back in place and reconnect power.
Spare fuse holder
(inside safety cap)
The product does not ship with a spare fuse; however, the safety cap has room for a
spare.
Always replace a blown fuse with the same type and rating.
CAUTION! Adhere to the respective national legal requirements for laser use during mounting!
Mounting must only be carried out by qualified persons! Before mounting, read and follow ALL
the safety recommendations in this manual.
The Scorpion™ Scan 3D EU is designed for overhead mounting. Make sure adequate ventilation is
provided around the product. Be sure to use a suitable hanging clamp and safety cable. Accessories
needed for safe and effective mounting are available from your local lighting distributor.
Pin
Live
Neutral
Earth
Page 7 of 44
Setup
International
L
N
Installed fuse
(held by plastic clip)
Safety cap