Bellman Visit 868 Mode D'emploi page 45

3. Connect a BE1270 Bellman Bed-shaker (accessory) to the socket n
(14) and press the Charger's Test Button (11). The Bed-shaker should
vibrate as long as the button is pressed. Please note that when the Test
Button (11) is pressed, the Charger is only powered by the back-up
batteries.
4. A Bellman Visit 868 transmitter is required to test the radio
reception. Press the test button on the Bellman Visit 868 Transmitter.
The Bellman Visit 868 Wrist Receiver will emit a light signal and
will vibrate via the connected Bed-shaker. Please note that the Wrist
Receiver itself does not vibrate when it is placed in the Charger.
5. The Bellman Visit 868 Wrist Receiver is used around the wrist just
like a wristwatch.
The BE1560 Bellman Visit 868 Wrist Receiver is placed in the BE1570
Bellman Visit Wrist Receiver Charger in order to charge it and to connect,
via the Charger, a BE1270 Bellman Bed-shaker (accessory) which is
placed under the pillow to wake up the user. Charging is controlled by the
Wrist Receiver and takes up to 8 hours. During charging, the LED (12) on
the Wrist Receiver will light up green.
To charge the Wrist Receiver:
1. Angle the Wrist Receiver slightly outwards so that the 2 small holes
in the edge of the Wrist Receiver point downwards and move it
towards the lower moveable part of the Charger
2. Press the Wrist Receiver and the moveable button downwards
3. Move the upper part of the Wrist Receiver towards the back edge and
release carefully. The green LED (12) should light up.
3
1
2
43
DE
DK
ES
FI
FR
GB
GR
HU
IT
NL
NO
PL
PT
SE
APP