Oase PondoVac 5 Notice D'emploi page 21

Connecting the hoses and nozzles
How to proceed:
 I
1. Attach the discharge hose to the outlet and twist it clockwise (bayonet closure).
– If only coarse dirt particles >1 mm (e.g. leaves or hair) are to be removed, you can allow the waste water to flow
back into the pond / pool via the fine filter bag.
– Do not allow muddy water to flow back into the pond / pool.
2. Attach the suction hose to the inlet.
3. Fit extension tubes and the desired nozzle to the suction hose with handle.
– Universal nozzle: For removing pond sludge without vacuuming up the pond gravel.
– Algae nozzle: For separating and removing string algae.
– Brush nozzle: For removing stubborn dirt.
– Surface cleaning nozzle: For cleaning large, smooth surfaces.
– Wet suction nozzle: For removing dirty or residual water for operation as a wet vacuum cleaner
N O T E !
• The more tubes that are used, the higher the tube frictional resistance. This leads to a reduction of the
suction capacity.
• Set up the vacuum cleaner on ground that is not much higher than the water level so as not to impair the
suction capacity.
The following conditions must be met:
• Allow the dirty water to drain out into a drain or far enough away from the pond to ensure that it cannot flow back into
the pond.
• Completely unwind the power and extension cable.
– Ensure that the cables are not bundled together or coiled up.
Operation
• Switch on the vacuum cleaner at the power switch.
• The suction power can be adjusted with the slide in the suction hose handle.
– To increase the suction: Move the slide forwards.
– To reduce the suction: Move the slide backwards.
• Clean the vacuum cleaner after each use. (→ Maintenance and cleaning)
– Recommendation: Vacuum up clean water before cleaning. This will wash out the dirt particles.
N O T E !
The vacuum cleaner and seals will be subjected to excessive strain if the vacuum cleaner is moved when the
tank is full.
• Empty the tank before moving the vacuum cleaner.
- EN -
21