Wired Connection - Elkron TEL600EXT Guide Rapide

POWER SUPPLY AND CONNECTION TO THE ROUTER
TEL600EXT is powered by a 12Vdc - 1A adapter, supplied as standard. Before running the learn procedure in the system, connect
it to the same router that the control unit is connected to:
The camera can be connected to the router in two alternative ways:
1)

WIRED CONNECTION:

Connect the Ethernet cable, included in the package, between the camera and your router. Power up the camera. At the end of
the initialisation phase (about 1 minute), wait for the yellow LED on the camera to turn on fixed. This indicates that the internet
connection has been established.
The camera has the network setting in DHCP.
2) WIRELESS CONNECTIONS:
First connect the Ethernet cable between the camera and the router. Use the Finder software to enter the local camera
programming (to download and launch the Finder software, connect to the website www.elkron.it).
Select the IP address of the camera and press the "Open Web Page" button.
When you log in for the first time, enter the following and press "Login":
USER NAME: admin
PASSWORD: cX+HsA*7F1
The password change page will be displayed. Enter a new password and repeat the entry (changing the user name is optional).