Kress Elektrowerkzeuge 108 AS 1,3 Mode D'emploi page 26

26 English
 Remove the battery from the charger.
 Pull the mains plug!
 Check that there are no foreign bodies in the
EN
charging compartment. Reinsert the battery.
Battery is faulty.
 Use a new battery.
Operation
FC-HT 08/12, FC-HT 08/18
Batteries used
FC-HT 08/12
NiCd battery with a rated voltage
of 12 V d.c.
Batteries used
FC-HT 08/18
NiCd battery with a rated voltage
of 14.4 - 18 V d.c.
Charging the battery
Only put original batteries into the battery
charger!
 Plug the charger into the mains.
 Push the battery into the charger as far as the
stop. The LED lights up green.
Charger ready for operation.
Start the charging process by press-
ing the Set button. The LED lights up
red
During the charging process, both the battery
and the charger heat up.
Charging process completed. The
LED lights up green.
Unplug the charger from the mains if the
charger is unattended.
Charging not possible
LEDs do not light up.
Battery is too hot or too cold.
The charging process begins automatically as
soon as the battery reaches a temperature within
the permissible range.
Short-circuiting between the charging contacts.
 Remove the battery from the charger.
 Pull the mains plug!
 Check that there are no foreign bodies in the
AkkuBS_CN-EN / 1004
charging compartment. Reinsert the battery.
Battery is faulty.
 Use a new battery.
Operating the power tool
Removing the battery
To remove the battery 5, press the release but-
ton(s) VIII and pull the battery out of the power
tool.
Inserting the battery
Use only original KRESS batteries with the volt-
age given on the type plate of your machine.
The use of other batteries can lead to injuries and
danger of fire.
 Set the rotational direction switch V to the
middle position to prevent it being switched
on accidentally.
 Insert the charged battery 5 into the handle
until you feel it click into place.
On/Off
Press or release the On/Off switch VI.
Changing the speed
The On/Off switch VI can be used for infinitely var-
iable speed control. Light pressure on the On/Off
switch VI causes the machine to rotate slowly;
with increased pressure, the speed increases.
Selecting the rotary direction
Only operate the rotational direction switch V
when the machine is at a standstill!
 Grip the rotational direction switch V on both
sides and set the required rotary direction.
Clockwise rotation:
For drilling and fixing screws.
Anticlockwise rotation:
For loosening and removing screws
and nuts.
Important! Always press the rotational direction
switch V up to the stop on the housing, i. e. until
you feel it engage.
When the rotational direction switch V is in its mid-
dle position, the machine cannot be switched on.
Operation