Publicité
Les langues disponibles
Les langues disponibles
1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
Fitting kit
- 2 screws BHC 5x25 big head
- 2 screws BHC 5x20 big head
- 2 rubber spacers Ø6mm L5mm
- 4 plastic washers Ø5mm
Fitting instructions
- Remove the original screen.
- Fit the Ermax screen by using 2 screws BHC 5x25, 2 plastic washers and the rubber spacers on the upper holes
(see picture below: the spacers must be placed between the screen and the motorcycle); and the 2 screws BHC
5x20 with the remaining washers at the bottom.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* Screens damaged by an inadequat washing are not guaranteed (abrasive, corrosive ... products, solvent, thinner, benzine ...). Wash immediately brake or battery fluid which may flow on accessories.
Rubber spacers
ADAPTABLE ON MT-07 TRACER 2016 → ∞
« CAUTION »
FITTING INSTRUCTIONS
ERMAX SCREEN
Estimated mounting time: 10 mn
Top view
Publicité
