Kathrein K Power Saving EXE 159 Mode D'emploi page 13

Kathrein power saving
If an EXE 159 is operated alone or together with other multi-switches that bear the
Kathrein Power Saving logo, Kathrein Power Saving can be activated by setting the
stand-by switch to "ON". If a receiver in the cascade is switched on, the LNB is powered
through the end multi-switch.
Multi-switches without Kathrein Power Saving do not give signalling to the
end multi-switch. The stand-by switch must be set to "OFF" for permanent
powering of the LNB.
PIN code protection
The multi-switch is protected by a PIN code in order to prevent the set userband from
being used/disturbed by another subscriber. This should be specified in the receiver
settings.
A fixed PIN has been assigned to each userband.
UB 1
Frequency
974
(MHz)
PIN 151
UB 2 UB 3 UB 4
1,076 1,178 1,280
052 133
UB 5 UB 6
1,382 1,484
124 205 196
4 / 8
UB 7 UB 8 UB 9
1,586 1,688 1,790
187 178 099