YBA Genesis IA3A Livret D'utilisation page 6

Genesis IA3A Integrated Amplifier
Discovering your IA3: Front view
CD
Source
1 2
1
ON/OFF switch: Use this button to switch ON or switch OFF your IA3A.
2
Source selector: Selects between the six different inputs.
3
Display: Displays current status of your IA3A.
4
IR sensor: Point the remote control to this zone to control your IA3A from a distance.
5
Volume control: Two toggle switches control the volume.
0
1
2
3 2
4
5
6
Page 6
G e n e s i s I A
3 4
Using your YBA remote control
Point your remote control to the IR receiver located in the display window
of your IA3A.
0
Select the device you want to control between AMP, CD and AUX. To
control the IA3A, you need to select AMP button.
Note: AMP will remain the active function until you select another device.
1
SOURCE+/SOURCE-: Press SOURCE+/SOURCE- to skip to the desired
source.
VOLUME+/VOLUME-: Press + to increase volume, or - to decrease the
2
output volume of the amplifier. This is a universal control and does not require
specific source selection.
3
VIEW: Hold (> 3 seconds) the display brightness dims. Hold again and the
display turns off. Hold again and the display turns on.
4
FCT: Hold to store the current volume level.
5
AUDIO: Press to return to the stored volume level.
6
MUTE: Press to mute. Press again to exit mute.
Note:
PRESS means a short press on a key while HOLD means to keep the key
pressed for more than 3 seconds.
www.ybahifi.com
3
Volume
63
5 3