Belkin TuneCast 3 Mode D'emploi page 6

Operating Instructions
Storing and Using Presets
1. To store a preset, select the desired frequency using "
and hold the desired preset button (1 or 2) for two seconds (the status bar will give
you visible feedback). An audible beep sounds in the transmitted audio when the
new frequency is programmed. The TuneCast 3 display reflects the change when the
memory button is released by showing which memory button was pressed along
with the frequency saved in that memory position.
2. To select one of your preset frequencies, momentarily press "1" or "2". This will
instantly tune the TuneCast 3 to the frequency stored in that preset.
NOTE: Storing a preset will memorize the frequency as well as the current mono/stereo setting.
Stored Preset
Memory Presets
Operating Instructions | 03
" or " " buttons. Press