Introduction; Products; Handling And Transport - Ferroli AQUA1 PLUS 90 HT Manuel D'installation Et Maintenance

Installation and maintenance manual
1

INTRODUCTION

This installation and maintenance manual is to be
considered an integral part of the heat pump
(hereafter referred to as equipment).
The manual must be kept for future reference until
the heat pump itself has been dismantled. This
manual is intended for both the specialised installer
(installers – maintenance technicians) as well as
the end user. The installation modes to be
complied with in order to achieve a correct and
safe operation of the equipment as well as
methods of use and maintenance are described in
this manual.
In case of the sale of the equipment or the
change of owner, the manual must accompany
the equipment to its new destination.
Before installing and/or using the equipment, read
this instruction manual carefully and, in particular,
chapter 4 relating to safety.
The manual must be kept together with the
equipment and, in any case, it must always be at
the disposal of the qualified personnel in charge of
installation and maintenance.
The following symbols are used inside the manual
in order to rapidly find the most important
information
:
Information on safety
Procedures to follow
Information/ Suggestions
1.1

Products

Dear Customer,
Thank you for having purchased this product.
Our company has always paid a great deal of
attention to environmental problems, therefore, it
has used technologies and materials with a low
environmental impact to manufacture its products
in conformity with RAEE 2012/19/UE – RoHS
2011/65/EU community standards.
2

HANDLING AND TRANSPORT

The equipment is supplied in a cardboard box (*).
must be carried out carefully so as not to damage
the equipment enclosure if this is carried out with
knives or cutters to
packaging.
After having removed the packaging, make sure
that the unit is intact. If in doubt, do not use the
equipment and seek
technical staff.
In conformity with
regulations, make sure that all the accessories
supplied have been removed before discarding
the packaging.
WARNING! Packaging items (staples,
polystyrene, etc.) must not be left
within the reach of children as they are
dangerous.
For the entire period in which the equipment
remains idle, waiting to be used, it is opportune to
protect it from atmospheric agents.
(*) Note: at the manufacturer's discretion, the type
of packaging may be subject to change.
2.1
Receipt
In addition to the units inside the packs are
contained accessories and technical
documentation for use and installation. Verify
that the following components:
• Safety valve
• Exhaust Tronchetto
• Mounting plate
• Installation and maintenance
• User manual
Use a fork-lift truck or a
pallet truck in order to
unload the equipment: it
is opportune for these to
have a load capacity of
at least 250 Kg.
The packaged
equipment must be put in
a vertical position during
all the loading
operations.
The unpacking operations
open the cardboard
help from authorised
environmental protection
pag. 2 / 19