Publicité
Les langues disponibles
Les langues disponibles
The rotating beacon is attached to the vehicle roof using a built-in magnetic base. It
should be installed so that it is well visible from all sides. We recommend also screwing
the lamp base onto the vehicle roof, since substantial knocks or also contact with low
branches can occur while driving. For this you require three self-cutting screws with 3 mm
diameter (not included in the scope of delivery).
The device is connected to the 12/24-voltage cigarette lighter. The coiled cable is 2 m long
when extended.
The LED-rotating beacon has 2 possible functions that can be set by pressing the small,
red switch on the 12/24-volt plug:
1. Rotating light
The lamp glass can be unscrewed if necessary.
Technical data:
Voltage:
Number of LEDs:
Operating modes:
Measurements:
Length of cable:
Plug:
Weight:
Operating temperature:
E- test number
Disposal:
Electronic devices are recycable materials and should not be disposed of with
household waste. Dispose of the product at the end of its useful life according to
the applicable regulations.
Copyright by
All rights reserved. It is not permitted without written approval from Berger + Schröter to reproduce these operating instructions. It is
also not permitted to reproduce extracts in any form that have been created or processed by use of electronic, mechanical or chemical
procedures. Technical changes can be made at any time without prior announcement. The operating instructions are corrected regu-
larly. We assume no liability for technical and typographical errors and their results.
2. Triple flash
12/24 Volt
60 units
Rotating light – flashing light 2-times
Height 9 cm , lamp glass-Ø approx. 8.5 cm,
height of lamp glass 5.5 cm
extendable from approx. 50 – 200 cm
12/24 volt plug with selector switch
integrated for the cigarette lighter.
450 grams
-30°C to +50°C
E13 10R – 0412764 , Societé nationale de Certification et
d'homologation, L-5201 Sandweiler
(GB) Installation and operating in-
structions LED-Rotating beacon
for fixed installation
rt.-No. 20200
IMPORT NT: You require a special permit ac-
cording to STVZO §52 to operate the rotating
beacon.
Please inquire at your road approval office
(traffic authority)
www.berger-schroeter.de
2
Publicité
