Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
B. Use a 3.5mm to 3.5mm audio cable (included) to connect an external audio device
headphone socket to the AUX socket on the device.
Power connection
Before connecting the AC power cord, make sure you have completed all other
connections.
• Prior to use, check that the mains voltage is the same as the mains voltage stated
on the device.
• Connect the power plug into an electrical outlet.
• Connect the plug of the power cord into the AC power socket of the device
• The device is now in standby mode. The standby LED indicator
Power ON/OFF – Standby
Press the
button on the device
control to switch it ON. The LED indicator
up.
Press the
button on the device
control to switch the device to standby mode. The LED Indicator
Disconnect the power plug from the electrical outlet if you want to switch the device
OFF completely.
Please note:
If the device is not in use (no input), it will automatically go into standby mode
after 15 minutes.
If the device's external input signal is too low, it will automatically go to standby
mode after 15 minutes. Please increase the input signal of your externally connected
device.
MODE selection
Press the SRC button
on the device's remote control to select the desired mode.
LED Indicator
Mode
Please note:
If the device source is in BT mode, and the BT connection is no longer active or out
of range, the LED indicator
If the device source is in HDMI ARC mode, and there is no active input signal, the
LED indicator
5
on the device, or BT, OPTICAL, HDMI ARC, AUX button
2
1
2
Red
Green
Standby
AUX
will flash blue.
5
will flash white.
or press the
1
5
for the last used source mode will light
or press the
1
3
Blue
BT
will light up red.
5
button
on the device's remote
A
button
on the device's remote
A
will light up red.
5
4
Orange
OPTICAL
8
.
C
5
White
HDMI ARC
EN 09
Publicité
Table des Matières
