Safety Notes - Chauvet DJ Obey 40 Mode D'emploi

Limited
Warranty

Safety Notes

Obey 40 User Manual Rev. 9
FOR WARRANTY REGISTRATION AND COMPLETE TERMS AND CONDITIONS PLEASE VISIT
OUR WEBSITE.
For Customers in the United States and Mexico:
For Customers in the United Kingdom, Republic of Ireland, Belgium, the Netherlands,
Luxembourg, France, and Germany:
Chauvet warrants that this product shall be free from defects in material and workmanship under normal
use, for the period specified in and subject to the exclusions and limitations set forth in, the full limited
warranty on our website. This warranty extends only to the original purchaser of the product and is not
transferable. To exercise rights under this warranty, you must provide proof of purchase in the form of an
original sales receipt from an authorized dealer that shows the product name and date of purchase.
THERE ARE NO OTHER EXPRESS OR IMPLIED WARRANTIES. This warranty gives you specific legal
rights. You may also have other rights that vary from state to state and country to country. This warranty is
valid only in the United States, United Kingdom, Republic of Ireland, Belgium, the Netherlands,
Luxembourg, France, Germany and Mexico. For warranty terms in other countries, please consult your
local distributor.
These notes include important information about the mounting, use, and maintenance of this
product. Read these notes before using the product.
• Always connect the product to a grounded circuit to avoid the risk of electrocution.
• Make sure the power cord is not crimped or damaged.
• Always disconnect the product from the power source before cleaning it or replacing the fuse.
• Never disconnect the product from the power source by pulling or tugging on the cord.
• If mounting the product overhead, always secure it using a safety cable.
• Make sure there are no flammable materials close to the product when it is operating.
• The product is for indoor use only! It is rated at IP20.
• Do not expose the product to rain or moisture.
• Make sure the voltage of the power source used for the product is within the range stated on the
label or on rear panel of the product.
• Never connect the product to a dimmer or a rheostat.
• Always install the product in a location with adequate ventilation, and leave at least 20 in (50 cm)
between the product and adjacent surfaces.
• Be sure that no ventilation slots on the product's housing are blocked.
• Do not operate the product in an ambient temperature higher than 104 °F (40 °C).
• Always carry the product by its mounting sides.
• In the event of a serious operating problem, stop using the product immediately.
• Never try to repair the product. Repairs carried out by untrained people can lead to damage or
malfunction.
• If repairs are required, contact the nearest authorized technical assistance center.
See Contact Us for more information.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
Keep this User Manual for future reference. If you sell the product, give this manual to the next
owner.
www.chauvetlighting.com/warranty-registration
www.chauvetlighting.eu/warranty-registration/
Page 11 of 160