Honda Power Equipment HSS760A Manuel De L'utilisateur page 54

Track-adjustment (track type only)
ADJUSTMENT INTERVAL: Every year, before operation
Make sure the tracks are clean and dry before adjustment. The tracks
cannot be correctly adjusted if clogged with snow or debris, or coated
with ice.
With the snow thrower resting
on its tracks, check track
deflection
by pressing down midway
between the wheels with a force
of 49 N.
When correctly adjusted, track
deflection should be:
11–16 mm.
Adjusting procedure:
1.Loosen the left and right tension bolt lock nuts at the rear axle, and
turn the adjusting nuts to correctly tension both tracks.
2.After adjustment, tighten the lock nuts securely.
Torque 21.5 N•m
Tires (wheel type only)
CAUTION:
• Do not operate with a flat
tire. This may cause the
bead to come off.
• Over inflation can cause
premature tire failure.
Inflate the tires to manufacturer's recommended tire pressure.
Before each use, check the tire
pressure with an air pressure
gauge.
Pressure: 138 kPa
NOTICE: Do not inflate more than 159
kPa or tire damage may result.
11–16 mm
TRACK
LOCK NUT
ADJUSTING NUT
49 N
TENSION BOLT
51