General Safety - Dometic GROUP SinePower MSP 702 Notice D'emploi

Safety instructions
2.1

General safety

During construction of a 230 V
essential to have a circuit breaker (residual current circuit breaker) in-
stalled and a grounding bridge set by a trained professional, see chapter
"Connect multiple appliances" on page 48.
Electronic devices are not toys!
Keep electrical appliances out of reach from children or infirm persons. Do
not let them use the appliances without supervision.
Persons (including children) whose physical, sensory or mental capabili-
ties or lack of experience and knowledge prevents them from using the
appliance safely should not use this appliance without initial supervision
or instruction by a responsible person.
Use the device only as intended.
Do not operate the device in a damp or wet environment.
Do not operate the device near any flammable materials.
Do not operate the device in areas that are potentially explosive.
Maintenance and repair work may only be carried out by qualified person-
nel who are familiar with the risks involved and the relevant regulations.
2.2 Safety when installing the device
Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
Take the precautions necessary to ensure that children cannot interfere
with operation. Dangerous situations may occur which cannot be recog-
nised by children!
Do not expose the device to a heat source (such as direct sunlight or heat-
ing). Avoid additional heating of the device in this way.
For installation on boats
If electrical devices are incorrectly installed on boats, corrosion damage
might occur. Have the inverter installed by a specialist (marine) electri-
cian.
36
socket distribution circuit, it is absolutely
AC
SinePower