Electronic Control - Indel B TB28 BT DT Instructions D'utilisation

TB 28 BT DT

ELECTRONIC CONTROL

The device is equipped with a multi-level battery monitor that protects your vehicle battery against excessive
discharging when the device is connected to the on-board DC supply.
If the cooler is operated when the vehicle ignition is switched off, the cooler switches off automatically as
soon as the supply voltage falls below a set level. The compressor will start up again automatically in a few
minute when the voltage goes back to normal values.
Note: these values are measured at control unit input and/or on the DC socket.
BATTERY PROTECTION LEVEL
It is possible to set three different battery protection threshold levels:
VOLTAGE
PROTECTION POSITION
LOW
MIDDLE
HIGH
Read the "CONTROL PANEL USE" section to learn how to modify the battery protection level.
TB28BT DT_(DC)_IM_20190712
DISPLAY
CUT OFF (V)
1 Bar
2 Bars
3 Bars
14
12V
CUT IN (V)
9.4 10.9
10.9 12.4
11.2 12.8
24V
CUT OFF (V) CUT IN (V)
21.1 22.7
22.2 23.6
24.2 25.7