Selkirk SUPERVENT Directives D'installation Et Guide D'entretien page 13

5. Assemble the 2 side Brackets (point of triangle facing down) to
the Support Plate (flange up and threaded stud towards the wall) by
inserting the threaded studs into the oblong slots (see Figures 22 &
23). Install the supplied nuts on the threaded studs until snug, do
not tighten at this time as adjustments may be required. Set aside
and prepare the support bracing to secure the side brackets as per
the Framing Dimensions Table 3, Section B and Figure 21 (B).
Two options are described below for the installation of the Wall
Support and the Insulated Tee assembly. Follow Method A if
inserting an assembled Insulated Chimney Length and Insulated Tee
into the Wall Thimble prior to the Wall Support. Follow Method B
if securing of the Wall Support to the wall prior to the Insulated Tee
and the Insulated Chimney Length.
METHOD A
6. Install an appropriate Insulated Chimney Length such as a one
foot section (or longer if required-not to exceed 24 inches) to the
horizontal branch of the Insulated Tee. Lock securely into the Tee
branch by twisting clockwise. A Locking Band must then be installed
to secure the connection. Make sure the nut and bolt are facing down
to prevent any water from collecting in the Locking Band. The Tee
branch extension must protrude a minimum of 3" into the room.
Slot for Tee Cap Bracket
Support Bracket
Threaded Stud
Nut
Support
Plate
Threaded
Stud
(toward
wall)
Support Side
Brackets
FIGURE 22
UNDERSIDE VIEW OF THREADED STUDS AND NUTS
NOTE: THE CHIMNEY LENGTH MUST EXTEND AT LEAST
3" THROUGH THE WALL INTO THE LIVING SPACE WHERE
THE STOVE PIPE CONNECTOR WILL BE
ATTACHED TO THE CHIMNEY BRANCH.
Support Bracket
Threaded Stud
Support Plate
Nuts
Threaded
Stud (toward
wall)
7. From outside the building, slide the assembly (Chimney Length
installed on the Tee Branch) through the Wall Thimble ensuring the male
coupling on the Tee is facing upward. The Wall Thimble will provide
support until you are ready to install the Wall Support Assembly.
8. Place the assembled Wall Support against the wall (Support Plate
Flange up) directly below the Insulated Tee. Slide the Wall Support
up to the bottom of the Insulated Tee ensuring that the flange on the
top of the Support Plate is inserted into the female coupler.
9. Prior to securing ensure that the Insulated Tee assembly is plumb
and level and sitting flush on the Support Plate. Secure to the wall
through the pre-punched holes located on each side of the Wall
Threaded
Stud
and Nut
located at
rear of
Support
Plate
Pre-
Punched
Holes of
Support
Bracket
Support
Plate
Nut
FIGURE 23
FRONT VIEW OF WALL SUPPORT ASSEMBLY
13
Flange Up
Support
Brackets
Support Plate
Slot for Tee Cap
Bracket
Stud and Nut
located to front
of Support
Bracket