Publicité
Les langues disponibles
Les langues disponibles
Installation
Installation
NOTICE! Avoid cleaners containing organic
solvents, alcohols, and hydrocarbons.
Rinse with water after cleaning.
Supplies Required:
• (3) ³⁄₈" floor anchors and bolts
• Pipe sealant
• Piping to ½" NPT water supply inlet
• Piping to 1¼" NPT drain outlet
• Sign-mounting hardware
Local codes may require the installation of a
backflow prevention valve to complete proper
installation. Compliance with local codes is the
responsibility of the installer. Valve must be
tested annually to verify that it is functioning
properly. Backflow prevention valves are not
included with the fixture and may be supplied
by the contractor or purchased from Bradley
Corporation.
Step 1: Secure base to floor
1. Install three suitable anchors (supplied by
installer) for ³⁄₈" bolts in the floor.
2. Bolt the base to the floor anchors using ³⁄₈" bolts
(supplied by installer).
Step 2: Assemble eye/face wash
1. Assemble eye/face wash components as shown
on page 4.
• Apply pipe sealant (supplied by installer)
to all male-threaded pipe joints.
• Use the rubber grip pad provided or
a strap wrench around pipes when
tightening to prevent marring the Bradtect
protective, safety yellow coating. Place the
grip pad on the pipe, then put the wrench
over the grip pad and turn the pipe with
the wrench.
Step 3: Connect water supply
1. Connect the water supply piping (supplied by
installer) to the ½" NPT inlet on the eye/face
wash.
2. Connect the drain piping (supplied by installer)
to the 1¼" NPT drain outlet on the eye/face
wash.
3. Mount the safety sign to the wall using sign-
mounting hardware (supplied by installer).
Bradley • 215-155FW Rev. H; ECN 12-05-003C
8³⁄₈"
(212mm)
36"
(914mm)
to Bottom
of Base
®
All dimensions assume standard thread
engagement. Variations in manufacturing allow
for +/- ¹⁄₈" (3mm) per threaded joint. To find
the tolerance of a dimension, add the number
of thread joints in between a dimension and
multiply it by ¹⁄₈" (3mm).
10/18/2012
15½"
(394mm)
Ø 10"
(254mm)
5¼"
(133mm)
6"
(152mm)
S19-210FW
42⁵⁄₈"
(1082mm)
to Bottom
of Base
3
Publicité
