To Activate/Deactivate The Timer; Sleep Timer Setting; General Information; Maintenance - Kenwood HM-337-SG Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
Clock/timer operation
To activate / deactivate the timer
Press timer on/off button (TIMER ON/OFF but-
ton on the remote control). If activated, the icon
"TIMER" will appear on the display.
Notes:
The timer on will not be activated if the starting and
stopping time are the same.
If the selected source ("CD" , "TAPE" or "REC TU")
is not available when preset timer is reached, TUNER
will be selected automatically.
During timer setting, if no button is press within 7
seconds, the system will exit timer setting mode
automatically.

Sleep timer setting

If the sleep timer is activated, the system will
switch to standby mode after the selected time
has expired.
Each press of the SLEEP button on the remote
control decreases the timer period by 10 minutes.
The sleep timer can be set up to 90 minutes.
The display will change to sleep time display and
change as follows:
90 min - 80 min -70 min - 60 min - 50 min - 40 min
- 30 min - 20 min - 10 min - OFF - 90 min - 80 min...
The icon "SLEEP" will appear on the display.
While sleep mode is in active:
To deactivate the sleep timer
Press SLEEP button on the remote control or press
the
button to turn the power off.
Note:
If timer off and the sleep off are all activated, the sys-
tem will switch to standby mode by the earlier timer
set.
16
EN

General information

Maintenance

Cleaning the cabinet
• Use a soft cloth slightly moistened with a mild
detergent solution. Do not use a solution con-
taining alcohol, spirits, ammonia or abrasive.
Cleaning discs
• When a disc becomes dirty, clean it with a
cleaning cloth, wipe the disc from the center
out. Do not wipe in circular motion.
• Do not use solvents such as benzene, thinner
commercially available cleaners, or antistatic
spray intended for analogue records.
Cleaning the heads and tape path
• To ensure good recording and playback qual-
ity, clean the heads, the capstans and pres-
sure rollers after every 50 hours of tape opera-
tion.
• Use a cotton swab slight moistened with clean-
ing fluid.
• You also can clean the heads by playing a clean-
ing tape once.
Caution on condensation
Condensation (of dew) may occur inside the unit
when there is a great difference in temperature
between this unit and the outside. This unit may
not function properly if condensation occurs. In
this case, leave the unit for a few hours and re-
start the operation after the condensation has dried
up.
Be specially cautious against condensation in the
following circumstances:
When this unit is carried from one place to an-
other across a large difference in temperature,
when the humidity in the room where this unit is
installed increases, etc.
Warning notice
In most cases it is an infringement of copyright to
make copies of tapes or discs without the per-
mission of the copyright owners. Anyone wishing
to copy commercially available tapes or disc should
contact the mechanical copyright protection soci-
ety limited or the performing rights society lim-
ited.

Publicité

Table des Matières
loading

Table des Matières