Candy CFNI3760E Mode D'emploi page 8

In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.
Place the appliance on the floor or at a 45° angle,
as it is necessary to work on the bottom of the
appliance.
Take off the bottom right-hand hinge by removing
the screws, pin and washers, then remove the
lower door.
Mark and break the left-hand slot on the panel, in
the insert area.
Remount the hinges and doors working from
bottom to top,
Put the appliance in an upright position and wait
two hours before turning it on.
REVERSING THE OPENING OF THE DOORS
Remove the bottom right hinge by unscrewing the
screws, pin and washers, then remove the bottom
door
Remove the caps (A) and (B), loosen the screws
and partially remove the panel making sure not to
damage the rear electric part
Flip the top left-hand hinge found in the
accessories kit.
To reverse the handles: remove the outer caps
from the right-hand side of the doors.
2 Hours
Remove the screws from the central hinge and
remove the top door.
Unscrew the right hinge.
Fit the panel, and secure with the screws and
caps.
Unscrew the handles from the left-hand side and
move them to the right-hand side, then position
the outer caps on the left-hand side of the doors.
7 EN