Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Angle function 2:
Angle function 2 1. measurement
The measurement result is determined by the 360° inclination sensor.
!
The back of the device can be used as a reference surface for
measuring angles.
Important notices
• The laser points to the location that will be measured.
No objects may get into the laser's line of measurement.
• The device compensates the measurement for different room
temperatures. Therefore allow the device a brief adaptation period
when changing locations with large temperature differences.
• The device is only conditionally useable in outdoor areas and cannot
be used in strong sunlight.
• The measurement results of outdoor measurements may be influenced
or falsified by rain, fog and snow.
• In unfavourable conditions, e.g. with poorly reflecting surfaces, the
maximum deviation may be greater than 3 mm.
• Carpeting, upholstery or curtains will not reflect the laser optimally.
Measure to flat surfaces.
• Measurements made through glass (window panes) can falsify
measurement results.
• An energy-saving function switches the device off automatically.
• Clean with a soft cloth. Water may not be allowed to penetrate
the housing.
Error codes:
Err204:
Calculation error
Err208:
Internal fault
Err220:
Replace the battery
Err252:
Temperature is too high: > 40°C
Err253:
Temperature is too low: < 0°C
Err255:
Received signal too weak or measuring time too long
Err256:
Received signal too strong
Err261:
Outside the measuring range
Err500:
Hardware fault
14
EN
2. measurement
1x
2x
result
height
Publicité
Table des Matières
