Instructions Of Use; Accessories; Technical File - Weelko S03 Mode D'emploi

CONTENT
On arrival of the package, check the pre-
sence of the following items:
- Steriliser

INSTRUCTIONS OF USE

1. Fill the steriliser with 80% of the
quartz beads and close the lid.
2. Press the switch button to switch
your device on. The red light will turn on
and the steriliser will start heating the
quartz beads.
3. After 10-12 minutes, when the
red light goes off, put into the device the
items to be sterilised, such as scissors,
blades, etc. Place them vertically among
the quartz beads.
4. Heat the items during 20-30 se-
conds. After this time, use protective
gloves and pliers to extract them.
5. When the steriliser reaches the
maximum temperature of 200ºC, the light
turns off automatically and the device
stops heating. If you don't switch the
steriliser off, it will restart again once the
temperature has dropped.
WARNING
EN
• To process the high-temperature ste-
rilization of the tools, it is necessary to
clean the machine in advance. Wipe it
with a cloth before inserting the quarz
beads.
• While the machine is operational, avoid
covering it with cotton towels, plastic
bags, etc.
• Do not use any tools in this machine
that cannot stand high temperatures,
such as plastic spatulas or mask sticks.
MAINTENANCE
• The quartz balls and inner housing
need to be cleaned after everyday use.

ACCESSORIES

REFERENCE
40003

TECHNICAL FILE

Weights and Packing size (cm)
sizes
Gross weight (kg)
Product size (cm)
Working cha- Capacity
racteristics
Temperature
Preset working time
Electrical Rated voltage
characteris-
tics
Frecuency
Rated power
DESCRIPTION
Bag of quarz beads
17 x 17 x 18
1 Kg
16x 16 x 16
152 ml
200ºC
15 min
220V-240V
50/60 Hz
75 W
© 2020 Weelko
www.weelko.com
Importer: Weelko Barcelona, S.L.
ESB65397556