Eurotops 40920 Mode D'emploi page 14

R 5252 / ET525
B. INTRODUCTION
1. Power input
4. SET
7. Aerial
10. SCAN
13. Temperature/Day-Month Display
16. Adaptor
C. SETTING
1) Power, battery insertion and replacement.
- USB Power supply
Insert the plug on cable (15) into the power input port (1) then connect the other end of the cable to a standard USB port
on a computer.
- Battery power supply
Open the battery compartment (3) and insert 4 AA LR06 1.5 V batteries, taking care to follow the polarity as indicated.
Close the battery compartment.
- Replacing the back-up battery.
Open the battery compartment (3) and remove the AA batteries if necessary.
Open the back-up battery cover (2) using a screwdriver.
Remove the old battery and insert a CR2032 battery, taking care to follow the polarity indicated.
Close the cover and the battery compartment.
2) Main control adjustments:
- Press SET (4) for 3 seconds and the year will begin to flash.
- Press the UP (5) or DOWN (6) buttons to set the year, then press SET (4) to confirm, next the month
(12) will flash.
- Press the UP (5) or DOWN (6) buttons to set the month (12), then press SET (4) to confirm, next the day will flash.
- Press the UP (5) or DOWN (6) buttons to set the day (12), then press SET (4) to confirm.
- Press the UP (5) or DOWN (6) buttons to set the time format (12 or 24 hour clock), then press SET (4) to confirm,
next the hour will flash.
2. Back-up battery cover
5. UP
8. FM
11. VOL -
14. Speaker:
16
3. Battery compartment
6. DOWN
9. VOL +
12. Hour/Year Display
15. Charging cable