Connecting The Speaker Output Terminals - Pioneer GM-5400T Mode D'emploi

Section
03 Connecting the units
2 Twist the battery wire, ground wire
and system remote control wire.
3 Attach lugs to wire ends. Lugs not sup-
plied.
Use pliers, etc., to crimp lugs to wires.
1 Lug
2 Battery wire
3 Ground wire
4 Connect the wires to the terminal.
Fix the wires securely with the terminal
screws.
1 System remote control terminal
2 GND terminal
3 Power terminal
10
En
4 Terminal screws
5 Battery wire
6 Ground wire
Twist
7 System remote control wire
Connecting the speaker
output terminals
1
using nippers or a cutter by about 10 mm
and twist.
2
not supplied.
Use pliers, etc., to crimp lugs to wires.
1 Lug
2 Speaker wire
3
speaker output terminals.
Fix the speaker wires securely with the term-
inal screws.
Expose the end of the speaker wires
Attach lugs to speaker wire ends. Lugs
Connect the speaker wires to the
Twist