Using The Cr-389 Remote Control - Arcam T61 Mode D'emploi

Using the CR-389 remote control

Ensure that the FM mode is selected using
the FM/DAB toggle button. The FM LED above
the FM/DAB button is lit briefly when FM is
These buttons allow access to individual preset stations.
To select a preset press the corresponding keypad button.
For presets 9–16, press and hold the corresponding
preset button for one second. Use the Tune buttons to
access FM memory presets 17 to 30.
This button toggles between
NOTE: DAB (Digital Audio Broadcast) refers to Arcam
DAB tuners such as model DT81.
T61
8
FM/DAB
selected.
Preset memory buttons
MODE (Tuning mode)
PRESET and TUNE modes.
MENU (RDS mode)
This button scrolls through RDS modes, when available.
DISP (Display)
This button allows you to dim or switch off the tuner display.
TUNER
FM DAB
FM
MENU DISP
DAB
1 9 2 10 3 11 4 12
5 13 6 14 7 15 8 16
MODE BAND
SP1
SP2
ENTER DISP
SEL
PHONO AUX CD TUNER
AV DVD VCR TAPE
AMPLIFIER
RPT
PROG DISP
CD
CR-389
STANDBY
This button switches the tuner (and the amplifier if
appropriate) between 'On' and 'Standby'.
Tune buttons
These buttons enable you to scroll through the
stored station selections one at a time, or to tune
up or down, depending on the Tuning mode.
BAND
This button toggles between FM and AM.
Amplifier controls
These buttons offer basic control over Arcam
amplifiers, such as the A65, A75 or A85.
CD player controls
These buttons offer basic control over Arcam CD
players, such as the CD62, CD72, CD82 or CD92.
NOTE: Remember to install the two AAA batteries
supplied before trying to use your remote control.
Do not place anything in front of the display area on the
tuner (where the IR receiver is located), or the remote
control may not work.